Can somebody describe how to configure the RRC at the radio side to transmit? Is there a reference for the configuration/cabling.
When using the PC-Client I observe the following issues:
a) Connection is fine and audio starts to flow
b) When pushing the PTT knob, the audio mutes but no TX switching happens on the radio side. After a few attempts of pressing the PTT, the RRC on the radio side hangs-up and can only be recovered by re-starting through the Web interface.
The same set-up used for CV-I control from a RRC on the controlling side using HRD works fine.
I downloaded and installed PC-Client SW RRC version 1.0.12 for 32bit and the firmware up-date for the RRC-1258-CRC_v2.21_2010-09-24 today and tried again. The problem when pushing the PTT remains. the RRC-1258 Radio Controller hangs-up, looses the connection and re-boots when pushing the PTT.
Mike - any idea?
