Author Topic: rc 1216 via ip  (Read 3961 times)

ea5zj

  • Newbie
  • *
  • Posts: 20
    • View Profile
rc 1216 via ip
« on: 2024-09-02, 13:46:59 »
Hello everyone. I am installing 1216 via IP.  I can click with relays and everything is perfect.
But I can't get it to change automatically. 
The question is......what does this mean about Kenwood?
Which one should I choose if I have ts2000?
I have tried all the combinations and it is not possible for me. 
My Control says switch off or not connected. 
I have matched ports on remote antenna and ccr control.
In control you only have to match the port with the same one on the switch and nothing else. What did I forget?
It took hours but I don't see the error. Thank you.
« Last Edit: 2024-09-02, 13:58:55 by ea5zj »

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3041
    • View Profile
    • sm2oan
    • Email
Re: rc 1216 via ip
« Reply #1 on: 2024-09-02, 13:54:25 »
Kenwood (IF) is what you normally use if you want the AS-1289 to ask for the frequency from the radio.
remeber that you need to have a CAT cable from the Radio-RRC com2 to the Radio CAT port
com 2 should be set to mode 4 and that all three set to the same baudrate

73 de mike

ea5zj

  • Newbie
  • *
  • Posts: 20
    • View Profile
Re: rc 1216 via ip
« Reply #2 on: 2024-09-02, 14:10:23 »
Thanks for the quick response.
I don't understand either.
My rs232 of the ts2000 is occupied by CCR in the tower.
Control at home, not used with 2.
I use USB for both the transmitter and the rotor, and it works.
I also use rc2000 and it's always perfect.
I understood remoterig via ip tells the switch where to go.
Isn't that so?
Excuse my ignorance. Google translations are not very good.

Photo my control in house. Is a Antenna Switch 1269
« Last Edit: 2024-09-02, 14:16:58 by ea5zj »

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3041
    • View Profile
    • sm2oan
    • Email
Re: rc 1216 via ip
« Reply #3 on: 2024-09-02, 14:22:06 »
i don't know what you mean by
"My rs232 of the ts2000 is occupied by CCR in the tower."

if you mean that you allready have connected the Radio-RRC to the Radio-CAT port all is OK

The AS-1289 talks to the Radio via the CAT cable, the RRC does not know anything about the radio, it only transfer data

but if you already us com 2 for controlling the radio all is OK as the AS-1289 can share the connection with the control software.

So if you set Radio-RRC settings with the correct ip nummer (radio-RRC) and correct port(13010)  and serial setting to 9600 it should work and on the main page you should see the "Current frequency" following the radio

73 de mike

ea5zj

  • Newbie
  • *
  • Posts: 20
    • View Profile
Re: rc 1216 via ip
« Reply #4 on: 2024-09-02, 18:58:34 »
working now.
thanks!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
ea5zj