« previous next »
Pages: [1]

Author Topic: Rotator cabeling  (Read 10213 times)

OH1MA

  • Newbie
  • *
  • Posts: 5
    • View Profile
    • Email
Rotator cabeling
« on: 2013-08-23, 16:17:27 »
What is connector numbers?
I try to connect Wep switch 1216H to DCU-1 (Idiom press Rotor-EZ) via RS232

I do not have RS-232 Adapter 9PF 1216H, i must make it, but I need diagram of this adapter

2 ----> data out    pin?
3 <---- data in      pin ?
5 ------ gnd           pin?
7 ------ 8
8 ------ 7
Logged

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3041
    • View Profile
    • sm2oan
    • Email
Re: Rotator cabeling
« Reply #1 on: 2013-08-23, 18:53:28 »
Logged

OH1MA

  • Newbie
  • *
  • Posts: 5
    • View Profile
    • Email
Re: Rotator cabeling
« Reply #2 on: 2013-08-24, 08:32:48 »
I think this white 5 pin connector inside Webswitch pins are

1 GND
2 RX
3 TX
4 ?
5 +3.3V
So it need level converter for RS232

Am I right?

Jaakko
Logged

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3041
    • View Profile
    • sm2oan
    • Email
Re: Rotator cabeling
« Reply #3 on: 2013-08-24, 20:24:47 »
Hi

On the page below there is a drawing

/mike


http://www.webswitch.se/wp/?page_id=335
Logged
Pages: [1]
« previous next »