PTT with the K3/0 Mini

[K1UO - Larry]

I recently changed over to the K3 mini and have cw working fine and SSB working fine.  The PTT via a footswitch connected to the PTT jack on the K3/mini works ok on my local LAN radio setup but when I switch profiles over to the K3 at the remote site via WAN I cannot get the PTT to key the radio there.  what simple little thing am I missing to allow me to use the footswitch to key up the remote  K3.  I am using a Yamaha CM500 plugged into the side jacks on my K3/mini.  As I mentioned this all works via my LAN radio setup just not WAN.  Using Mode 7 of Com 1 for serial settings and 14 for Radio Program Mode.

[K1UO - Larry]

Like I thought. " simple little thing missing" ....  It was a loose jumper in the RRC at the Remote end. 

[K1UO - Larry]

OK..now the next question.  The STATUS page of the remote RRC1258 Has a Command out port value of 1024 and a Command in value of 13002.    The remote router is configured correctly to allow port 13002 for both UDP and TCP.  I notice the SIP and Audio ports in/out values for 13000 and 13001 match each on the RRC1258 Status page  but the Command in/out ports do not and nothing I do changes the Command out port value from 1024.   Is this normal?