I'm running latest firmware
Info
Name Value
Company Microbit
Product 1258
PID 4
Version 7
HW 8
Software 2.86
Bootloader 1.10
Compiler 4.6.2
Build May 28 2015 11:12:06
ROM/RAM 476084/42016
ETH-RAM 2944 (max 3kB)
USB-RAM 15348 (max 16kB)
Battery-RAM 4
ResetSrc 0 [3]
Last WD Reset 10
Uptime 0 Days, 0 Hours, 1 Mins, 41 Secs
Serial number 8174
MAC address 00:1e:fd:01:96:8e
IP address 192.168.100.169
Netmask 255.255.255.0
Gateway 192.168.100.254
DNS 192.168.100.254
I'm trying to make Winkey work using the control RRC.
I understand that I'm supposed to set the COM3/COMextra port to Winkey, point N1MM+ at that, and we are good.
Here's the problem: The manual does not reflect what we see on screen. I totally understand technically what to do, but can't figure the UI out.
My serial settings has:
Serial settings
COM1 mode
COM1 baudrate
COM1 data bits
COM1 stop bits
COM1 parity
COM1 rts/cts
COM1 terminator (hex)
COM2 mode
COM2 baudrate
COM2 data bits
COM2 stop bits
COM2 parity
COM2 terminator (hex)
That's it. And the mode has no WINKEY setting or COMextra.
ON I/O settings,
I have Out0 mode, Out1 mode and Out2 mode -- none of which have a Winkey setting in the drop down (Thought it does have some RTTY options). (Is Out2 COMExtra???)
Trying to set this up for IARU, so quick help is needed.
73, Gerry W1VE
