K3 will not turn on, but works if manually turned on

[K1IKE-Joe]

I'm working on my third RRC, this one is an Elecraft K-3.

I'm accessing the K-3 using my Elecraft Nano App on my Android phone.  The K-3 will not turn on when I connect to it over my local LAN IP address.  If I first turn on the K-3, I can connect to it and everything seems to work fine.  When I disconnect the K-3 powers off.  If I try to reconnect the K-3 will not power up, but the Nano app shows that I am connected.

Any ideas?  The 1258 RRC is Version 7, HW 8,Software 2.87, and the K-3 software is up to date.

Joe, K1ike

[sm2o]

Have you connected the cable from the RRC I/O jack to the ACC jack where the K3 start signal is connected ? The out0 should also be set to "connected".  See cable drawings in the K3 twin chapter in the manual.

73 de mike

[K1IKE-Joe]

I must have forgotten to Apply the out0 option.  It is working fine now.

Thanks, Joe, K1ike