Hi I have a Yaesu G-450A. I am trying to set it up with the RRC-1216H with the 1216L. I have follow the online instructions. But I do not see the A/D value changing during the calibration . The A/D shows 1, 2, or a 3.... do not see it change beyond this. I have disconnected the pot from the the 1216L, and manually actuated the rotater. The Multimeter show the resistance rise from near zero to about 20 K. Below is the system Information:
Company Microbit
Product 1216H WebSwitch
Model HAM
Software 4.23
Hardware 3
Bootloader 1.12
Build Nov 3 2015 09:01:45
1216L HW >= 5, FW 5
S/N 3130
PID 4
Uptime 0 Days, 0 Hours, 22 Mins, 11 Secs
========================================
MAC 00:1e:fd:00:ca:12
IP address 192.168.105.237
Netmask 255.255.255.0
Gateway 192.168.105.1
DNS 192.168.105.1
========================================
Max available memory 18201
DNS status OK, remoterig.com = 213.180.92.20
Dynamic DNS status Inactive
NTP status Disabled
Rotator status Initialized
Ping status (watchdog) Off
Active profile Default
Last WD Reset 5
TCP Error counter 0
My main concern is the A/D is not tracking the change in resistance...
