Author Topic: Paddle stops working when N1MM is running  (Read 5389 times)

K0PC

  • Newbie
  • *
  • Posts: 8
    • View Profile
Paddle stops working when N1MM is running
« on: 2016-04-05, 04:44:55 »
I have a K3 Twin setup that is working well with N1MM+ for logging. I am using the built in WinKeyer on COMExtra and it works fine for sending the function key messages but the paddle doesn't work. If I shut down N1MM+ then the paddle works as expected. Restart N1MM+ and the paddle is useless again.

I haven't used the remote setup in a while but I believe it used to work correctly. I am running the version 2.90 firmware.

Does anyone have any ideas where I should look?

Thanks,
Pat KØPC