HB9EDM de LA6BNA
Yes, I have tried to connect SignaLink to the panel side. It functions, but I am not still satisfied with how I have managed to "trim" the set up. There is a tendency to lock the system in TX when I trig the PTT. (Possibly because I have not succeeded finding the appropriate sound card levels still???)
Jumpers in SignaLink set this way:
SignaLink-side RJ-45-side (standard pin-numbers; not Kenwood/Yaesu-style)
G --------------------- 6 (GND)
G --------------------- 4 (MIC-GND)
PTT ------------------- 5 (PTT)
MIC ------------------- 3 (MIC)
(J3 in the SignaLink NOT set. I tried that too, but got only trouble with locking in TX-mode all the time.)
Speaker-cable (3,5 stereo-cable) between RemoteRig-box and SPKR on SignaLink.
RJ-45-cable into MIC on RemoteRig-box instead of microphone.
Front panel connected to TTL on RemoteRig-box as usual.
Read the manual for SignaLink very well, and be extremely careful with the adjustment of sound-card properties. At firs I did not care much about that, but then I did not get any results at all.
Best regards
Geir, LA6BNA
(By the way - Do anyone have a set up to suggest for RRC-Micro PC-client and TS-480 so that the Remote station can be controlled by front panel in the usual way and the RRC-Micro alternatively only by changing profile via Internet??)
(Disregard this last question - I found the error: I forgot to set baudrate 9600 for communicating over the COM-port on the radio!)
