Twin K3/0, N1MM+ correct settings

[UA3AP]

Folks, was away from the remoterig stuff for 7+ years. Now is back and wish to reactivate it. Have old RRC1258MKII purchased I believe in 2012 or 2011. K3/0 unit (S/N18) and using the N1MM+
Facing the following issue - N1MM+ reads K/0 unit, but can't switch it to TX CW (no keying at all). Settings - COM1 mode - mode 7, USB COM1 port yes, COM2 mode logical parallel with COM0, Use USB COm2 port - No.
In N1MM+ for CW DTR is always on, RTS is always off.
What I'm doing wrong? Thanks, 73 Sergei UA3AP

[dj0qn]

Hi Sergei,

I don't think you can key using DTR/RTS. I don't know N1MM, but either you must set the spftware
to use CAT for sending CW, or else just use the RRC's built-in Winkey emulation.

Set COMEXTRA/COM3 to use Winkey under the serial settings and plug-in your USB cable. Set N1MM
to use the Windows virtual port that COMEXTRA/COM3 was given.

73,
Mitch DJ0QN / K7DX

[UA3AP]

Mitch, done! It works now. Many thanks  for your support and warm wishes to FL. 73, Sergei UA3AP (aka K3AO)

[cx6vm]

Sergei

You can look at W1UE instructions also

http://www.remoterig.com/forum/index.php?topic=1536.0

73,
Jorge
CX6VM/CW5W


Enviado desde mi iPhone utilizando Tapatalk