Hi
I have the following issue with my remote TS-480:
when TXing in CW the first 1 or 2 characters are corrupted but then it works fine for the rest of the passage. Next passage, again: first 1 or 2 characters corrupted, then fine.
I am able to test the behaviour only in 80m, where I can RX my own signal on the control site but other OMs on the radio site have confirmed the issue on other bands too.
I would almost certainly exclude an RFI issue and I would rather say it has to do with some buffer but I have already set buffer size, jitter and delays to the max value almost
I have the following settings:
Control Site (cable connection):
Rx jitter buffer size 16
Rx jitter delay 15
Audio packet size (ms) 40
RTP tx mode 1
....
UDP cmd min-data-size 10
....
Lf delay ms [0-500] 400
Key delay ms [0-250] 200
Radio Site (WiFi connection to fiber router):
Rx jitter buffer size 16
Rx jitter delay 15
Audio packet size (ms) 40
RTP tx mode 1
Disable audio tones 0
The typical ping time is 50ms
Even if annoying, I can still live with this issue in normal QSOs but it is almost impossible to work DX stations or contests.
I haven't been able to find any similar 3D in the forum. Any suggestion?
73 de IZ4AFL