SIP Contact Host Problems

[Michael]

Hi all:

Well up and running again, everything seems to be running fine except I have a SIP contact host issue.
When I put in my DynDns assigned host, I don't get any audio and the remote isn't functioning.
However, when I replace the DynDns host with my ISP assigned IP, it establishes a connection and everything's fine. 
Any fix for this? The only thing I know to do now is watch for the IP change to update the SIP contact host field.

TNX & 73:

Michael

[Jan (Microbit)]

Have you checked the "DNS status" on the Status Page?

[Michael]

Hi Jan:

On the Control RRC, the DynDns Status shows:
OK, remoterig.com = 193.202.110.185.
On the radio RRC, the DynDns status is unknown.

Thanks:

Michael

Have you checked the "DNS status" on the Status Page?

[Jan (Microbit)]

Hi Jan:

On the Control RRC, the DynDns Status shows:
OK, remoterig.com = 193.202.110.185.
On the radio RRC, the DynDns status is unknown.

Thanks:

Michael

Note that I didn't ask about the DynDNS status, but about the DNS status, which you indeed did answer about though you call it "DynDNS" instead of just "DNS"

If you enter your DynDNS hostname as SIP contact, which DNS status do you get then? (Should not be "OK, remoterig.com = 193.202.110.185" then, but something like "OK, yourdynsdomain=X.X.X.X"

[Michael]

Hi Jan:

Here's the info from the status page from my control RRC.
As you can see, the DNS status is unknown.
This is the same as the radio RRC.  Perhaps you can check the rest of the info to see if everything is correct.

TNX AGN & 73:

Michael

Status

Name   Value
Control panel   OFF
Radio   OFF
SIP status   Idle
Last SIP error   None
RTP Timeout   0
SIP Timeout   0
Rx Jitter buffer size   4
Rx Jitter delay   3
SIP Out port   10100
SIP In port   10100
Audio Out port   0
Audio In port   0
Command Out port   10500
Command In port   10500
External SIP In port   10100
External Audio In port   10300
External Cmd In port   10500
Other party   0.0.0.0
Input 0   High
Input 1   High
Input 2   High
Output 0   Low
Output 1   Low
Output 2   Low
DNS status   Unknown
Active profile:   Default
PTT status:   OFF

Hi Jan:

On the Control RRC, the DynDns Status shows:
OK, remoterig.com = 193.202.110.185.
On the radio RRC, the DynDns status is unknown.

Thanks:

Michael

Note that I didn't ask about the DynDNS status, but about the DNS status, which you indeed did answer about though you call it "DynDNS" instead of just "DNS"

If you enter your DynDNS hostname as SIP contact, which DNS status do you get then? (Should not be "OK, remoterig.com = 193.202.110.185" then, but something like "OK, yourdynsdomain=X.X.X.X"

[Jan (Microbit)]

I think you checked the "DNS Status" too soon after Applying settings(=restarting the RRC). It will take awhile before DNS Status becomes something else than "Unknown".